Wiegand.h -

Remember: Implement it correctly once, and you’ll support every major card reader on the market. Have you battled Wiegand jitter or bit‑order issues? Share your experience below.

#ifndef WIEGAND_H #define WIEGAND_H #include <stdint.h> #include <stdbool.h>

// Configuration structure typedef struct uint8_t pin_d0; uint8_t pin_d1; uint32_t bit_timeout_us; // Max gap between bits (e.g., 2500) uint32_t packet_timeout_us; // Gap to finalize packet (e.g., 15000) bool pullup_enable; // Use internal pullups? wiegand_config_t; wiegand.h

Introduction If you’ve ever worked with a proximity card reader (125kHz or 13.56MHz), a fingerprint scanner, or an old-school magnetic stripe swipe, you’ve almost certainly encountered the Wiegand protocol. In the embedded world, the wiegand.h header file represents the standard interface for driving these devices via GPIO on microcontrollers like Arduino, ESP32, STM32, or Raspberry Pi Pico.

bool validate_26bit(uint32_t raw) uint8_t even_parity = parity_even((raw >> 25) & 0x7F); // Bits 1..13? uint8_t odd_parity = parity_odd((raw >> 1) & 0x3FFF); // Bits 14..25? return (even_parity == ((raw >> 25) & 1)) && (odd_parity == ((raw >> 0) & 1)); Remember: Implement it correctly once, and you’ll support

void IRAM_ATTR on_d1_falling() record_bit(1);

while (1) vTaskDelay(pdMS_TO_TICKS(1000)); #ifndef WIEGAND_H #define WIEGAND_H #include <stdint

#endif // WIEGAND_H 1. Interrupt‑Driven Bit Capture The only reliable way to read Wiegand is via edge-triggered interrupts on the D0 and D1 pins. Polling will miss microsecond pulses.

void app_main() wiegand_config_t cfg = .pin_d0 = GPIO_NUM_4, .pin_d1 = GPIO_NUM_5, .bit_timeout_us = 2500, .packet_timeout_us = 15000, .pullup_enable = true ; wiegand_init(&cfg); wiegand_set_callback(card_received);

// Example ISR (pseudo-code) void IRAM_ATTR on_d0_falling() record_bit(0);

// Callback type for completed card reads typedef void (*wiegand_callback_t)(uint32_t facility_code, uint32_t card_number, int bits_received);