New- Hints And Kinks For The Radio Amateur < Recommended — 2027 >

Let’s face it: half the fun of amateur radio is the tinkering. We love solving the little problems—the RF in the shack, the cable mess behind the desk, the soldering iron that’s never hot when you need it. Here’s a fresh batch of hints and kinks to save you time, money, and frustration. The problem: You slip a ferrite bead over a coax cable, but it rattles around and slides right off the bend. Not effective.

Not always, but in a pinch, stranded 18-gauge wire soaked in flux outperforms no wick at all. Keep a 6" piece pre-fluxed in a tiny ziplock bag in your go-kit. 3. The "Eyeglass" SMA Wrench (Free & Perfect) The problem: SMA connectors need to be finger tight plus 1/8 turn . Overtighten, and you’ll snap the center pin or ruin the female receptacle (especially on cheap HTs or SDR dongles). New- Hints and Kinks for the Radio Amateur

Tried-and-true tricks, fresh twists, and shop-tested solutions for the modern shack Let’s face it: half the fun of amateur

Stick a metal ruler (12" or 24") directly to the fiberglass or wooden mast using double-sided foam tape, aligned vertically with the antenna element. Use a small spring clamp or a plastic clothespin on the ruler as a temporary stop. The problem: You slip a ferrite bead over

Buy a silicone baking mat (meant for cookies, about $10–15). They are heat resistant to 450°F, non-slip, and have a slight lip. The best part: the non-stick surface means solder balls don’t adhere—they just roll into a corner for easy vacuuming.