1nz Ecu Pinout Access
| Sensor | Connector | Pin | Signal Wire | Voltage/Spec | | :--- | :--- | :--- | :--- | :--- | | | E6 (B) | 23 | Light Green | 3.0-3.8V @ idle; ~1.0V @ decel | | TPS (VTA) | E6 (B) | 22 | Blue/Red | 0.5V (Closed) to 4.5V (WOT) | | Engine Coolant Temp | E6 (B) | 20 | Red/White | 2.5V cold to 0.2V hot | | Cam Position (VVT-i) | E6 (B) | 9 | Yellow | 5V square wave | | Crank Position (NE) | E6 (B) | 8 | White | 5V square wave |
| Component | Connector | Pin | Control Type | Wire Color | | :--- | :--- | :--- | :--- | :--- | | | E5 (A) | 10 | Switched Ground (12V feed) | Blue | | Injector 2 | E5 (A) | 9 | Switched Ground | Yellow | | Injector 3 | E5 (A) | 8 | Switched Ground | Green | | Injector 4 | E5 (A) | 7 | Switched Ground | Red | | Igniter (IGT) | E5 (A) | 11 | 5V Trigger (Ignition timing) | White | | Fuel Pump Relay | E7 (C) | 4 | Switched Ground (Priming) | Green/Red | | VVT Solenoid | E5 (A) | 12 | Switched Ground | Blue/Yellow | 1nz ecu pinout
The 1NZ-FE uses a simple ON/OFF VVT-i. The ECU pin E5-12 (VVT Solenoid) sends a ground signal to advance cam timing. At idle, duty cycle is 0%; under load, it pulses. Actuator Outputs (Making the Engine Run) These pins are where the ECU controls the mechanical parts. Do not use a standard test light on these; use a Logic Probe or LED test light (low current). | Sensor | Connector | Pin | Signal
The Toyota 1NZ-FE is the legendary 1.5-liter inline-four engine found in the Toyota Prius (Gen 1 & 2), Yaris (Vitz), Echo, Scion xA, xB, and the Japanese-market Toyota bB. While reliable, electrical gremlins or swap projects often require a technician to interface directly with the Engine Control Unit (ECU) . Actuator Outputs (Making the Engine Run) These pins
If you have no spark and no injector pulse, check pin E5-5 (Black/Red). If this is dead with the key on, the EFI main relay is not engaging or the ECU is not pulling the relay coil to ground. Sensor Inputs (How the ECU Sees the World) The 1NZ-FE uses a Speed-Density system (MAP sensor) rather than a MAF, except for some California-spec models.
| Function | Connector | Pin | Wire Color (Typical) | Condition | | :--- | :--- | :--- | :--- | :--- | | | E5 (A) | 1 | White | Constant 12V | | IG Power (Main Relay) | E5 (A) | 5 | Black/Red | 12V with Key ON | | +BM (Sensor Power) | E5 (A) | 2 | Black/Orange | 12V via EFI relay | | Power Ground | E5 (A) | 17, 18 | Brown | Chassis Ground | | Sensor Ground | E6 (B) | 24 | White/Black | ECU Signal Ground |